How do you turn off the airbag light on a Honda Accord?

How to Reset a Honda Accord SRS Light

1. Straighten out a paperclip.
2. Pull down on the fuse panel cover under the steering column with your fingers to remove it.
3. Locate the small yellow plug in the fuse panel.
4. Unplug the power connector from the fuse panel.

How do I clear the air bag warning light?

How to Reset an Airbag Light

1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.

Why is my airbag light on in my Honda Accord?

If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.

Why does my airbag light stay on?

The airbag light indicates that something is wrong with the seatbelts or airbags. This means that it’s probably not safe to drive with the airbag light on. If it stays illuminated in your vehicle, we recommend having it towed to the dealership rather than driving it yourself.

How much does it cost to reset the airbag light?

Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.

Why is my airbag light on in my 2004 Honda Accord?

NHTSA reports that Honda is recalling 81,000 2004 – 05 Accord sedans because of an airbag sensor that was installed improperly. If owners see the airbag light go off, they should have their car serviced immediately. Under the recall, all owners will have the sensor wiring harness replaced.

How to reset the engine light on a 2003 Honda Accord?

How to Reset the Engine Light on a 2003 Honda Accord. Remove the nut from the negative black cable and wiggle the cable free. Place a piece of cardboard between the cable and the battery to ensure it doesn’t spring back into place. Press and hold the brake pedal for several seconds. This activates the tail lights,…

Why does my airbag light come on in my Honda Accord?

Honda Accord Airbag Light on Causes. Your airbag light is part of your Accord’s larger supplemental restraint system. It works in tandem with the system to protect you in the event of an accident. If all parts of this system are not working properly, it can cause the airbag light to come on.

How do you turn off the SRS light on a Honda Accord?

Figure 2. MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit.

Why do I need to Reset my airbag control module?

Even after a minor accident the airbag may not deploy but the seat belts will lock and airbag module will need to be reset because of crash data and crash codes that are stored in the airbag module. MyAirbags will reset your airbag control module back to its original manufacturer state clear of all codes, both soft and hard codes.