How many volts does a 60 amp alternator put out?

The simple answer is that under ideal conditions it will generate 60 amps into 12 volts.

Can an alternator produce 240 volts?

Therefore, you need an alternator that will produce at least 125 Amps. In reality, you need more than that, in order to still have 1500W after you get done converting it to 240V. Fortunately, without trying too hard, I could find 200A, 250A, and 300A (2400W~3600W) alternators … so this is definitely possible.

Can I use an alternator to power my house?

Yes, but it gets complicated an expensive. A standard car alternator is only 50–70amp at 12v. This is only about 4 amps. There are very few device in your house you can power this way.

How much power can an alternator generate?

Conventional alternator may only produce power for about 500 Watt to 600 Watt. But nowadays, a single alternator can produce power up to 2500 Watt, depending on the power demand. The power that can be produced by an alternator is determined by the alternator rating.

How do you wire a 120V generator to a 240V?

How to Convert 120V to 240V Generator

1. Select an appropriate transformer.
2. Connect the output power terminal from the 120V generator to the primary coil side of the transformer.
3. Connect the load to the labeled secondary side of the transformer.
4. Turn on the 120-volt generator.

How many volts can a car alternator produce?

The actual output voltage produced by the alternator will typically be about 1-1/2 to 2 volts higher than battery voltage. At idle, most charging systems will produce 13.8 to 14.3 volts with no lights or accessories on.

What amperage alternator do I need?

The amp rating of the alternator is matched to the vehicle’s electrical system. Older vehicles with fewer accessories may only need a 70- or 80-amp alternator, while a newer vehicle with lots of electronics and accessories may need a 120- to 160-amp alternator.

How many amps does it take to run a 1500 watt alternator?

The margin is all you would have to work with. The car’s alternator is designed to supply 12 volts, so 1500watts will require 125 amps. The best way to derive AC power from a DC power system is to use an inverter. Again though, there’s is not enough source power available.

What size alternator do I need for a 12V car?

You can find plenty of 12VDC to 240VC AC (m Car alternators are rated to generate power at ~12V DC x some number of amps. They don’t usually have a wattage number, but you can calculate it this way = Therefore, you need an alternator that will produce at least 125 Amps.

What happens if you put a 200 amp alternator in a car?

For example, you may have a 100 amp alternator in your vehicle and the turn signals have small wiring and will only use 10 amp of power. Upgrading to a 200 amp alternator will not affect these components. On externally regulated alternators you can still use the stock factory regulator.

How does amperage affect voltage in alternator?

By using Ohm’s Law, you can calculate that when amperage goes up, voltage will go down. The higher the amperage load is to the alternator’s maximum rated output, the lower the voltage will be. For example, if you have a 100 amp alternator and are using 80 amp, the voltage will be about 13.5V.