Is subnet ID same as gateway?

The subnet mask splits the IP address into the host and network addresses, thereby defining which part of the IP address belongs to the device and which part belongs to the network. The device called a gateway or default gateway connects local devices to other networks.

Can subnets talk to each other?

The short answer is that they can, but they need a router or layer 3 switch configured with the appropriate static routes to each network, or a dynamic routing protocol that learns the path from one subnet to another.

How do I ping an IP address in a different subnet?

1. Use Route Tables. Your route table will be where this is indicated.
2. Syntax. route add -p mask
3. Example. route add -p 192.168.1.0 mask 255.255.255.0 10.100.98.25 route add -p 192.168.0.0 mask 255.255.255.0 10.100.98.87.

What is the default gateway for 192.168 network?

The default gateway is 192.168. 0.1. Except for the packet for the local machine or for the subnet 192.168. 0.0/24, all packets sent by this PC for other networks will be routed through the gateway machine with 192.168.

What is DNS gateway?

Domain Name Service (DNS) numbers are IP addresses that a workstation or server uses to refer to specific servers that resolve domain names to IP addresses. A gateway IP refers to a device on a network which sends local network traffic to other networks. and the rest of the network.

What is my IP and gateway?

In the Command Prompt window, type “ipconfig” and press “Enter/Return” on your keyboard. You will see a lot of information generated in this window. If you scroll up you should see “Default Gateway” with the device’s IP address listed to the right of it.

How do I connect my computer to a different subnet?

How to Connect Computers That Are on 2 Different Subnets

1. Connect the computers to the network. Ensure that each connection eventually reaches a router or a routable switch.
2. Connect the routers to each other.
3. Allow time for the routing tables to update.

How do I connect two networks?

All you have to do in the router that connects the two networks it this:

1. Configure each of two Ethernet ports into different VLANs.
2. Assign each VLAN an IP address in one of your two networks.
3. Connect each port to the network that port’s VLAN has an IP address in.
4. Make sure the router is configured to do routing.

Can I ping a computer on a different network?

You can use the ping command to verify the connectivity between two network devices that are IP (Internet Protocol) based. To ping another network device using a computer running Windows, complete the following: To bring up the run dialog, press the Windows key + R. 1.1, you would type ping 192.168.

Can you ping a subnet mask?

It does, however, have another way to do a broadcast ping: just send a normal ping to a special IP address on your network. If my subnet mask were 255.255. 0.0 , then the ping address would be 192.168. $ ping 192.168.

Can IP address and default gateway be same?

Yes. A default gateway is an IP address that is specified in a device to enable it to communicate with other devices that are not in the same network. Normally it is an address of the router interface that is connected to a network. Yes, the default gateway IS an IP address, the IP address of your router.