What are elevator floor buttons called?
Table of Contents
hall call
Elevators are typically controlled from the outside by a call box, which has up and down buttons, at each stop. When pressed at a certain floor, the button (also known as a “hall call” button) calls the elevator to pick up more passengers.
What are the parts of an elevator called?
The different parts of an elevator include:
- Elevator car & shaft.
- The Sheave & Motor.
- Control unit.
- Counterweight.
- Machine drive.
- Counterweight guide rails.
- Guide rail fixing bracket.
- Car guide rail.
What is a elevator button?
Call Buttons are used to request an elevator. They are mounted 42″ above the finished floor and consist of an up button and a down button that illuminate to indicate the request has been received and an elevator is on the way. Hall Lanterns are used to indicate the arriving elevator and the direction it will travel.
What is elevator room called?
elevator machine room
A lift (or elevator) is a form of vertical transportation between building floors, levels or decks, commonly found in multi-storey buildings. A lift motor room (sometimes referred to as an elevator machine room), is a room that houses the machinery and electrical controls that operate a lift.
What is an elevator sheave?
A sheave is just a pulley with a grooves around the circumference. The sheave grips the hoist ropes, so when you rotate the sheave, the ropes move too. The ropes that lift the car are also connected to a counterweight (4), which hangs on the other side of the sheave.
Can you call an elevator?
“Calling the Elevator” or Call Button – Pressing the call button in the hallway will “call the elevator” to you, if the elevator is not in use and/or is located on a different level. Car – The elevator car transports passengers from one floor to another.
What does ND on elevator mean?
Nudge mode (or Nudging Service) is an elevator mode which when the door is held past a certain time, usually 30 seconds, and “nudges” closed while a buzzer, tone, or voice sounds, signaling to stand clear of the door.
What are floor selection buttons used for on an elevator?
Floor Selection Buttons are used to select floors that the elevator will stop at. The highest floor button shall be at 54″ above finished floor or lower. Buttons are 3/4″ diameter and illuminate on being pressed. Operation and Emergency Buttons are offset below the floor selection buttons.
How do you call an elevator in a hotel?
“Calling the Elevator” or Call Button – Pressing the call button in the hallway will “call the elevator” to you, if the elevator is not in use and/or is located on a different level. Car – The elevator car transports passengers from one floor to another.
Platform: The floor assembly on an elevator on which the passenger stands and/or the load is carried. Rail: The structural member (usually “T” shaped steel) fastened to the walls of a hoistway to guide the car and counterweight.
What is the function of the car in an elevator?
Car – The elevator car transports passengers from one floor to another. C.O.P. – The Car Operating Panel (C.O.P.) is the control panel inside the elevator that houses the floor buttons, the light switch, the alarm button, the emergency stop switch and optional key lock.